Turn your belt sander into a stationary machine. Master woodworker George Vondriska shows you the simplest way to construct a jig that will hold a belt sander securely to your workbench, making it easier and safer to sand typically difficult woodworking projects like small toy parts and irregular shapes.
You Might Also Enjoy
-
1:08Checking Joint Quality
Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process…
Watch Now >> -
3:40Concentric Variable Spaced Dovetails
Dovetails are widely viewed in the woodworking world as a mark of premium craftsmanship. Cutting them with variable spacing creates a strong visual appeal, and the appearance of a hand-cut approach. Master woodworker George Vondriska demonstrates how to use a router, dovetail jig and guide block to make concentric variable spaced dovetail joints without the…
Watch Now >> -
2:40Check for Slipping Router Bit Collet
Router bit collets do wear out, but it can be difficult to tell when. In this woodworking instructional video, master woodworker George Vondriska teaches you how to confirm that your jig’s router bit collet is still properly holding router bits without slipping.
Watch Now >> -
1:29Preventing Clamp Scars
You may just have found a new home for your old, worn out socks. Dave Munkittrick gives a quick and handy woodworking tip to prevent clamp scars that can damage your wood. Socks can help avoid the crippling effects that hand clamps are liable to have on your woodworking projects.
Watch Now >>
