Can you cut biscuit joints on the router table you use for your woodworking projects? Sure, but you’ll need to know the steps to get the fit right. Our master woodworker George Vondriska explains the setup of the router as a biscuit joiner and shows you how to make the cuts.
You Might Also Enjoy...
-
2:40Check for Slipping Router Bit Collet
Router bit collets do wear out, but it can be difficult to tell when. In this woodworking instructional video, master woodworker George Vondriska teaches you how to confirm that your jig’s router bit collet is still properly holding router bits without slipping.
Watch Now >> -
1:08Checking Joint Quality
Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process…
Watch Now >> -
2:29Belt Sander Bench Mount
Turn your belt sander into a stationary machine. Master woodworker George Vondriska shows you the simplest way to construct a jig that will hold a belt sander securely to your workbench, making it easier and safer to sand typically difficult woodworking projects like small toy parts and irregular shapes.
Watch Now >> -
1:038mm Shanked Router Bits
Did you know that your woodworking router can actually hold and use 8mm shanked router bits? Not 1/4″, not 1/2″, but 8 mm. Master woodworker George Vondriska discusses the calculated method to the madness, and introduces a must-have tool that will allow 8 mm shanked router bits to work in your router. Learn all about…
Watch Now >>
