There are many ways to taper table legs, and using the jointer is one of the easiest. It’s safe and you don’t even have to draw a line. George Vondriska demonstrates the quickest process for tapering a leg on the jointer.
Tags: Premium Videos
You Might Also Enjoy...
-
1:03Did you know that your woodworking router can actually hold and use 8mm shanked router bits? Not 1/4″, not 1/2″, but 8 mm. Master woodworker George Vondriska discusses the calculated method to the madness, and introduces a must-have tool that will allow 8 mm shanked router bits to work in your router. Learn all about
Watch Now >> -
4:05Can you cut biscuit joints on the router table you use for your woodworking projects? Sure, but you’ll need to know the steps to get the fit right. Our master woodworker George Vondriska explains the setup of the router as a biscuit joiner and shows you how to make the cuts.
Watch Now >> -
1:29You may just have found a new home for your old, worn out socks. Dave Munkittrick gives a quick and handy woodworking tip to prevent clamp scars that can damage your wood. Socks can help avoid the crippling effects that hand clamps are liable to have on your woodworking projects.
Watch Now >> -
2:28When working on your woodworking project, have you ever wondered why most dovetail jigs are a two-bit operation? Woodworking expert George Vondriska explains how through-pins and tails are cut on a jig, and when to use each of the two cutters required for the process. He also discusses why it’s so important to match the
Watch Now >>
