See how a regular hacksaw blade can be the best tool in your shop for spreading wood glue over the surface of a board or any wide, flat surface.
You Might Also Enjoy
-
3:23Climb Cutting on a Dovetail Jig
Router bit tearout is a nasty problem when you’re cutting dovetails. So master woodworker George Vondriska shows you how to avoid this devastating problem when completing your woodworking projects by using a technique on a dovetail jig called climb cutting.
Watch Now >> -
4:05Biscuit Joiner on a Router
Can you cut biscuit joints on the router table you use for your woodworking projects? Sure, but you’ll need to know the steps to get the fit right. Our master woodworker George Vondriska explains the setup of the router as a biscuit joiner and shows you how to make the cuts.
Watch Now >> -
2:32Re-Purpose Worn Push Pads
George Vondriska teaches you a great way to refurbish the push pads you use in your workshop. Instead of just tossing your old push pads out, George recommends cutting off the rubber padding from the bottom of the pad, and screwing the plastic handle to a piece of scrap wood, which you can turn into…
Watch Now >> -
3:59Adding Tannins to Wood
George Vondriska demonstrates a unique way to color wood using a simple iron acetate solution that creates a chemical reaction with the natural tannins in wood. If you are using a wood species with a low level of tannin, George shows you the process for adding tannins so that the iron acetate will have a…
Watch Now >>
