When turning a spindle on a lathe, it can be difficult for most woodworkers to mount the spindle blank parallel to the axis of the lathe, so George Vondriska teaches you how to find the center of the wood with a crosshatch and a four jaw chuck.
-
1:08
Checking Joint Quality
Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process…
Watch Now >> -
2:28
2 Bit Dovetail
When working on your woodworking project, have you ever wondered why most dovetail jigs are a two-bit operation? Woodworking expert George Vondriska explains how through-pins and tails are cut on a jig, and when to use each of the two cutters required for the process. He also discusses why it’s so important to match the…
Watch Now >> -
1:26
Cutting Laminate on a Table Saw
Master woodworker George Vondriska demonstrates the best way to safely cut perfectly straight plastic laminate with your table saw. You’ll learn that all you need are a couple of scraps to make a handy foolproof woodworking jig.
Watch Now >> -
3:23
Climb Cutting on a Dovetail Jig
Router bit tearout is a nasty problem when you’re cutting dovetails. So master woodworker George Vondriska shows you how to avoid this devastating problem when completing your woodworking projects by using a technique on a dovetail jig called climb cutting.
Watch Now >>