Applying veneer on your woodworking projects is easy when you know the necessary steps. Our master woodworker George Vondriska teaches you all of the details essential for completing the process, like choosing and applying the right glue and finding the best way to properly clamp the assembly.
You Might Also Enjoy...
-
2:32Re-Purpose Worn Push Pads
George Vondriska teaches you a great way to refurbish the push pads you use in your workshop. Instead of just tossing your old push pads out, George recommends cutting off the rubber padding from the bottom of the pad, and screwing the plastic handle to a piece of scrap wood, which you can turn into…
Watch Now >> -
1:038mm Shanked Router Bits
Did you know that your woodworking router can actually hold and use 8mm shanked router bits? Not 1/4″, not 1/2″, but 8 mm. Master woodworker George Vondriska discusses the calculated method to the madness, and introduces a must-have tool that will allow 8 mm shanked router bits to work in your router. Learn all about…
Watch Now >> -
1:07Economic Screwdriver Grips
Having a hard time getting a good grip on your screwdrivers? Use this quick tip from Dave Munkittrick to make your screwdriver handle larger and easier to grip.
Watch Now >> -
1:08Checking Joint Quality
Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process…
Watch Now >>
