George Vondriska teaches you how to utilize adjustable tongue and groove router bits to create perfect grooves for undersized plywood. He walks you through the easy step-by-step solution for removing the rattle from your doors and steamer trunks by adding or removing shims from the cutters.
You Might Also Enjoy...
-
1:07Economic Screwdriver Grips
Having a hard time getting a good grip on your screwdrivers? Use this quick tip from Dave Munkittrick to make your screwdriver handle larger and easier to grip.
Watch Now >> -
2:32Re-Purpose Worn Push Pads
George Vondriska teaches you a great way to refurbish the push pads you use in your workshop. Instead of just tossing your old push pads out, George recommends cutting off the rubber padding from the bottom of the pad, and screwing the plastic handle to a piece of scrap wood, which you can turn into…
Watch Now >> -
5:41Cutting Plugs and Using Plug Cutters
Make nearly invisible covers for screw heads with plugs cut from the same wood as your woodworking project. George Vondriska guides you through the procedure for cutting plugs using a drill press, plug cutter bit, bandsaw and George’s secret weapon: masking tape.
Watch Now >> -
1:08Checking Joint Quality
Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process…
Watch Now >>
