Master woodworker George Vondriska demonstrates a simple woodworking technique to eliminate tearout on your spindle turnings when transitioning from your square blank to the round part of your design. A WoodWorkers Guild of America (WWGOA) original video.
You Might Also Enjoy
-
2:10Build a Cribbage Board
George Vondriska and A.J. Moses discuss the process for making a cribbage board from scrap wood in your woodworking shop. These cribbage board plans are included in the WoodWorkers Guild of America (WWGOA) original video. Read the article Make a Cribbage Board with Peg Storage to get step-by-step instructions and a cut list for this…
Watch Now >> -
2:55Choosing a Brush for Your Top Coat
You’ve spent a lot of time on your project getting it ready to finish, so why not finish it right? If you’re going to apply four layers of stains or top coat with a brush, it’s important to use the proper brush for the job. A WoodWorkers Guild of America (WWGOA) original video.
Watch Now >> -
2:37Countertop Pen Materials
For a different look in your shop-made pens, try any of the various counter-top materials. Not only do they result in a beautiful pen, but you can get your materials for little or no money. A WoodWorkers Guild of America (WWGOA) original video.
Watch Now >> -
2:23Best Aerosol Nozzle
Are all aerosol can tips created equal? Nope, and you’ll see why as George Vondriska demonstrates the results from each type. A WoodWorkers Guild of America (WWGOA) original video.
Watch Now >>
splats and spindles are often not round, but almost oval shaped. how is this done? Ticket 23224
Dear Jon,
Thank you for your patience. In response to your question-
If you start out with a rectangular turning blank, and you stop turning before it is completely round, you will essentially have an oval.
Sincerely,
Paul
Woodworkers Guild of America Video Membership
thanks paul