George Vondriska demonstrates the easy woodworking technique for how to install a router bit in your router correctly. He recommends that you take the base off of the motor, then talks about the possible consequences of mounting the bit too far or not far enough.
-
1:03
8mm Shanked Router Bits
Did you know that your woodworking router can actually hold and use 8mm shanked router bits? Not 1/4″, not 1/2″, but 8 mm. Master woodworker George Vondriska discusses the calculated method to the madness, and introduces a must-have tool that will allow 8 mm shanked router bits to work in your router. Learn all about…
Watch Now >> -
2:14
Build Your Own Adjustable Woodworking Bench
Have you ever wanted the ability to raise and lower the benches in your woodworking shop while working on various projects? George Vondriska shows you how valuable and easy it is to have an adjustable bench in your shop.
Watch Now >> -
2:40
Check for Slipping Router Bit Collet
Router bit collets do wear out, but it can be difficult to tell when. In this woodworking instructional video, master woodworker George Vondriska teaches you how to confirm that your jig’s router bit collet is still properly holding router bits without slipping.
Watch Now >> -
3:36
Clamping Biscuits
It’s time to drop your standard woodworking clamps and check out these clamping biscuits. Master woodworker George Vondriska teaches you how they work and how they can be an easy solution in your woodworking shop for some of those more difficult-to-clamp joints.
Watch Now >>