Thinking of buying a vertical panel raiser for your router table? George Vondriska demonstrates how to safely use the bit and discusses some of the pros and cons of the vertical panel router bits and the classic horizontal panel bits.
You Might Also Enjoy...
-
2:32Re-Purpose Worn Push Pads
George Vondriska teaches you a great way to refurbish the push pads you use in your workshop. Instead of just tossing your old push pads out, George recommends cutting off the rubber padding from the bottom of the pad, and screwing the plastic handle to a piece of scrap wood, which you can turn into…
Watch Now >> -
1:42Mounting Router Bits
It is possible to mount a router bit incorrectly in your router collet, and that can spell disaster for your woodworking project. George Vondriska shows you how to properly insert and clamp router bits into your router.
Watch Now >> -
1:34Do I Really Need an Impact Driver?
Seeing is believing! Watch this demonstration and don’t be surprised if your next tool purchase is an impact driver. For more information about impact drivers check out the related impact driver product review.
Watch Now >> -
4:05Biscuit Joiner on a Router
Can you cut biscuit joints on the router table you use for your woodworking projects? Sure, but you’ll need to know the steps to get the fit right. Our master woodworker George Vondriska explains the setup of the router as a biscuit joiner and shows you how to make the cuts.
Watch Now >>
