Trial and error isn’t always the best choice for making cuts on your miter saw because it’s not precise and you could waste valuable wood. So George Vondriska gives you a simple tip that will avoid trial and error and help you be super precise. He recommends using a sacrificial fence to make your cuts beforehand, allowing you to check them on a piece of scrap before making the real cut.
You Might Also Enjoy...
-
4:05Biscuit Joiner on a Router
Can you cut biscuit joints on the router table you use for your woodworking projects? Sure, but you’ll need to know the steps to get the fit right. Our master woodworker George Vondriska explains the setup of the router as a biscuit joiner and shows you how to make the cuts.
Watch Now >> -
1:47Building a Kit Guitar
Building a guitar is an excellent test of a skilled woodworker’s craftsmanship, but if you’re like most people, you probably want to skip the long woodworking processes of shaping and sanding the body. So master woodworker George Vondriska gives you a quick rundown on a couple ready-made guitar kits that are available for you to…
Watch Now >> -
1:08Checking Joint Quality
Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process…
Watch Now >> -
1:038mm Shanked Router Bits
Did you know that your woodworking router can actually hold and use 8mm shanked router bits? Not 1/4″, not 1/2″, but 8 mm. Master woodworker George Vondriska discusses the calculated method to the madness, and introduces a must-have tool that will allow 8 mm shanked router bits to work in your router. Learn all about…
Watch Now >>
