It is possible to mount a router bit incorrectly in your router collet, and that can spell disaster for your woodworking project. George Vondriska shows you how to properly insert and clamp router bits into your router.
Tags: George Vondriska, mount router bits, Premium Videos, router bits
You Might Also Enjoy...
-
3:40Dovetails are widely viewed in the woodworking world as a mark of premium craftsmanship. Cutting them with variable spacing creates a strong visual appeal, and the appearance of a hand-cut approach. Master woodworker George Vondriska demonstrates how to use a router, dovetail jig and guide block to make concentric variable spaced dovetail joints without the
Watch Now >> -
1:26Master woodworker George Vondriska demonstrates the best way to safely cut perfectly straight plastic laminate with your table saw. You’ll learn that all you need are a couple of scraps to make a handy foolproof woodworking jig.
Watch Now >> -
2:32George Vondriska teaches you a great way to refurbish the push pads you use in your workshop. Instead of just tossing your old push pads out, George recommends cutting off the rubber padding from the bottom of the pad, and screwing the plastic handle to a piece of scrap wood, which you can turn into
Watch Now >> -
1:08Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process
Watch Now >>
