It can be tricky to clamp fences and jigs to the top of a cast iron band saw table because the webbing on the underside of the table gets in the way of your clamps. Fear not, George Vondriska teaches you a simple technique to create a flush surface on the bottom of your band saw table that will eliminate this problem.
You Might Also Enjoy
-
1:29Preventing Clamp Scars
You may just have found a new home for your old, worn out socks. Dave Munkittrick gives a quick and handy woodworking tip to prevent clamp scars that can damage your wood. Socks can help avoid the crippling effects that hand clamps are liable to have on your woodworking projects.
Watch Now >> -
5:41Cutting Plugs and Using Plug Cutters
Make nearly invisible covers for screw heads with plugs cut from the same wood as your woodworking project. George Vondriska guides you through the procedure for cutting plugs using a drill press, plug cutter bit, bandsaw and George’s secret weapon: masking tape.
Watch Now >> -
3:59Adding Tannins to Wood
George Vondriska demonstrates a unique way to color wood using a simple iron acetate solution that creates a chemical reaction with the natural tannins in wood. If you are using a wood species with a low level of tannin, George shows you the process for adding tannins so that the iron acetate will have a…
Watch Now >> -
2:40Check for Slipping Router Bit Collet
Router bit collets do wear out, but it can be difficult to tell when. In this woodworking instructional video, master woodworker George Vondriska teaches you how to confirm that your jig’s router bit collet is still properly holding router bits without slipping.
Watch Now >>
