A cross halving joint creates a rigid and sturdy joint without using glue or fastners. George Vondriska gives you step by step instructions on how to cut a strong cross halving joint using dado head in your table saw.
Make nearly invisible covers for screw heads with plugs cut from the same wood as your woodworking project. George Vondriska guides you through the procedure for cutting plugs using a drill press, plug cutter bit, bandsaw and George’s secret weapon: masking tape.Watch Now >>
When working on your woodworking project, have you ever wondered why most dovetail jigs are a two-bit operation? Woodworking expert George Vondriska explains how through-pins and tails are cut on a jig, and when to use each of the two cutters required for the process. He also discusses why it’s so important to match theWatch Now >>
Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your processWatch Now >>
Can you cut biscuit joints on the router table you use for your woodworking projects? Sure, but you’ll need to know the steps to get the fit right. Our master woodworker George Vondriska explains the setup of the router as a biscuit joiner and shows you how to make the cuts.Watch Now >>