Demonstrating on a tapered display case, George Vondriska teaches you why you should always make downhill cuts when doing a taper for a woodworking project to optimize the surface finish of the edge. He discusses which router bits you should use, and then shows you the expert woodworking techniques you’ll need to utilize to make the downhill cut.
You Might Also Enjoy...
-
3:40Concentric Variable Spaced Dovetails
Dovetails are widely viewed in the woodworking world as a mark of premium craftsmanship. Cutting them with variable spacing creates a strong visual appeal, and the appearance of a hand-cut approach. Master woodworker George Vondriska demonstrates how to use a router, dovetail jig and guide block to make concentric variable spaced dovetail joints without the…
Watch Now >> -
3:23Climb Cutting on a Dovetail Jig
Router bit tearout is a nasty problem when you’re cutting dovetails. So master woodworker George Vondriska shows you how to avoid this devastating problem when completing your woodworking projects by using a technique on a dovetail jig called climb cutting.
Watch Now >> -
2:49Acrylic and Polycarbonate Glass
Have you ever wondered what the differences are between acrylic and polycarbonate glass? George Vondriska explains what sets them apart and discusses some of the various woodworking projects that require each type. Watch and learn which type factors into your next woodworking plans.
Watch Now >> -
1:08Checking Joint Quality
Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process…
Watch Now >>
