Once you get the hang of it, sharpening gouges and round scrapers for your lathe on a low rpm grinder is very fast, letting you get back to turning quickly. The sharpening can be done freehand, but you’ve got to master a few tricks to make sure you get the sharpening right. Thankfully, the tricks are in this cutting edge video.
You Might Also Enjoy...
-
3:23Climb Cutting on a Dovetail Jig
Router bit tearout is a nasty problem when you’re cutting dovetails. So master woodworker George Vondriska shows you how to avoid this devastating problem when completing your woodworking projects by using a technique on a dovetail jig called climb cutting.
Watch Now >> -
1:038mm Shanked Router Bits
Did you know that your woodworking router can actually hold and use 8mm shanked router bits? Not 1/4″, not 1/2″, but 8 mm. Master woodworker George Vondriska discusses the calculated method to the madness, and introduces a must-have tool that will allow 8 mm shanked router bits to work in your router. Learn all about…
Watch Now >> -
4:05Biscuit Joiner on a Router
Can you cut biscuit joints on the router table you use for your woodworking projects? Sure, but you’ll need to know the steps to get the fit right. Our master woodworker George Vondriska explains the setup of the router as a biscuit joiner and shows you how to make the cuts.
Watch Now >> -
6:36Bridge Over Broken Guitar
Is the bridge of your guitar separating from the guitar top? You can save big bucks by making the repair yourself. You probably already have all the woodworking tools you need in your shop to fix the broken guitar, and if you follow master woodworker George Vondriska’s step-by-step directions in this video, you’ll gain all…
Watch Now >>
