Clamps without pads on the contact points can mark the surface of your project. You will learn from master woodworker George Vondriska how to apply inexpensive felt clamp pads to any clamp in your workshop to protect your woodworking project from unwanted blemishes.
You Might Also Enjoy...
-
2:40Check for Slipping Router Bit Collet
Router bit collets do wear out, but it can be difficult to tell when. In this woodworking instructional video, master woodworker George Vondriska teaches you how to confirm that your jig’s router bit collet is still properly holding router bits without slipping.
Watch Now >> -
5:41Cutting Plugs and Using Plug Cutters
Make nearly invisible covers for screw heads with plugs cut from the same wood as your woodworking project. George Vondriska guides you through the procedure for cutting plugs using a drill press, plug cutter bit, bandsaw and George’s secret weapon: masking tape.
Watch Now >> -
2:282 Bit Dovetail
When working on your woodworking project, have you ever wondered why most dovetail jigs are a two-bit operation? Woodworking expert George Vondriska explains how through-pins and tails are cut on a jig, and when to use each of the two cutters required for the process. He also discusses why it’s so important to match the…
Watch Now >> -
1:26Cutting Laminate on a Table Saw
Master woodworker George Vondriska demonstrates the best way to safely cut perfectly straight plastic laminate with your table saw. You’ll learn that all you need are a couple of scraps to make a handy foolproof woodworking jig.
Watch Now >>
