It’s very common to have a reveal between a leg and rail, which adds a nice detail to the piece of furniture. If you’re joining the pieces using a biscuit, don’t go through the rigamarole of changing the biscuit joiner’s fence to get the reveal. Use this simple trick instead.
Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your processWatch Now >>
Can you cut biscuit joints on the router table you use for your woodworking projects? Sure, but you’ll need to know the steps to get the fit right. Our master woodworker George Vondriska explains the setup of the router as a biscuit joiner and shows you how to make the cuts.Watch Now >>
Router bit collets do wear out, but it can be difficult to tell when. In this woodworking instructional video, master woodworker George Vondriska teaches you how to confirm that your jig’s router bit collet is still properly holding router bits without slipping.Watch Now >>