George Vondriska teaches you how to use a benchtop mortiser and a 45-degree V-block to cut a mortise at a 45-degree angle. He stresses the importance of taking the first cut slowly, so as to avoid the blade glancing off of the surface and affecting the cut quality.
George Vondriska teaches you a great way to refurbish the push pads you use in your workshop. Instead of just tossing your old push pads out, George recommends cutting off the rubber padding from the bottom of the pad, and screwing the plastic handle to a piece of scrap wood, which you can turn into…Watch Now >>
Bending wood is one of those techniques that can have a dramatic effect on a woodworking project, but many woodworkers shy away from it because it seems intimidating. Watch this demonstration by our expert woodworker George Vondriska to learn a simple, worry-free approach to bending wood quickly using a heated iron pipe.Watch Now >>
You may just have found a new home for your old, worn out socks. Dave Munkittrick gives a quick and handy woodworking tip to prevent clamp scars that can damage your wood. Socks can help avoid the crippling effects that hand clamps are liable to have on your woodworking projects.Watch Now >>
Did you know that your woodworking router can actually hold and use 8mm shanked router bits? Not 1/4″, not 1/2″, but 8 mm. Master woodworker George Vondriska discusses the calculated method to the madness, and introduces a must-have tool that will allow 8 mm shanked router bits to work in your router. Learn all about…Watch Now >>