For whatever reason, you may want to make skinny pieces of wood even skinnier, but the fence on your table saw doesn’t typically allow you to do so, until now. George Vondriska developed a simple sled jig that you can create using a 10″ board and an old push pad to provide greater control over the small pieces you hope to rip and make even smaller.
You Might Also Enjoy
-
1:08Checking Joint Quality
Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process…
Watch Now >> -
5:41Cutting Plugs and Using Plug Cutters
Make nearly invisible covers for screw heads with plugs cut from the same wood as your woodworking project. George Vondriska guides you through the procedure for cutting plugs using a drill press, plug cutter bit, bandsaw and George’s secret weapon: masking tape.
Watch Now >> -
2:282 Bit Dovetail
When working on your woodworking project, have you ever wondered why most dovetail jigs are a two-bit operation? Woodworking expert George Vondriska explains how through-pins and tails are cut on a jig, and when to use each of the two cutters required for the process. He also discusses why it’s so important to match the…
Watch Now >> -
2:29Belt Sander Bench Mount
Turn your belt sander into a stationary machine. Master woodworker George Vondriska shows you the simplest way to construct a jig that will hold a belt sander securely to your workbench, making it easier and safer to sand typically difficult woodworking projects like small toy parts and irregular shapes.
Watch Now >>
