For some woodworking projects you will need to cut pieces that are tapered. George Vondriska shows you a great woodworking technique for cutting tapered pieces using a table saw, a piece of hard board as a straight edge and some screws. It’s quick, easy and a safe way to make taper cuts on a table saw.
-
2:32
Re-Purpose Worn Push Pads
George Vondriska teaches you a great way to refurbish the push pads you use in your workshop. Instead of just tossing your old push pads out, George recommends cutting off the rubber padding from the bottom of the pad, and screwing the plastic handle to a piece of scrap wood, which you can turn into…
Watch Now >> -
2:28
2 Bit Dovetail
When working on your woodworking project, have you ever wondered why most dovetail jigs are a two-bit operation? Woodworking expert George Vondriska explains how through-pins and tails are cut on a jig, and when to use each of the two cutters required for the process. He also discusses why it’s so important to match the…
Watch Now >> -
1:08
Checking Joint Quality
Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process…
Watch Now >> -
4:14
Applying Veneer
Applying veneer on your woodworking projects is easy when you know the necessary steps. Our master woodworker George Vondriska teaches you all of the details essential for completing the process, like choosing and applying the right glue and finding the best way to properly clamp the assembly.
Watch Now >>