George Vondriska demonstrates the proper woodworking technique for using both sides of a Porter Cable 4212 dovetail jig to cut dovetail joints on all four sides of your project. He suggests labeling each of the pieces so that you’ll be confident that the layout is correct when you go to make your cuts.
You Might Also Enjoy...
-
1:08Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process…
Watch Now >> -
4:05Can you cut biscuit joints on the router table you use for your woodworking projects? Sure, but you’ll need to know the steps to get the fit right. Our master woodworker George Vondriska explains the setup of the router as a biscuit joiner and shows you how to make the cuts.
Watch Now >> -
2:49Have you ever wondered what the differences are between acrylic and polycarbonate glass? George Vondriska explains what sets them apart and discusses some of the various woodworking projects that require each type. Watch and learn which type factors into your next woodworking plans.
Watch Now >> -
2:32George Vondriska teaches you a great way to refurbish the push pads you use in your workshop. Instead of just tossing your old push pads out, George recommends cutting off the rubber padding from the bottom of the pad, and screwing the plastic handle to a piece of scrap wood, which you can turn into…
Watch Now >>
