Crosscutting lumber with a miter gauge on your tablesaw is a quick process, but there are always size limitations. George Vondriska gives you a tip to gain some extra capacity by borrowing a commercial manufacturing technique for squaring big parts.
You Might Also Enjoy...
-
1:34Do I Really Need an Impact Driver?
Seeing is believing! Watch this demonstration and don’t be surprised if your next tool purchase is an impact driver. For more information about impact drivers check out the related impact driver product review.
Watch Now >> -
1:038mm Shanked Router Bits
Did you know that your woodworking router can actually hold and use 8mm shanked router bits? Not 1/4″, not 1/2″, but 8 mm. Master woodworker George Vondriska discusses the calculated method to the madness, and introduces a must-have tool that will allow 8 mm shanked router bits to work in your router. Learn all about…
Watch Now >> -
2:32Re-Purpose Worn Push Pads
George Vondriska teaches you a great way to refurbish the push pads you use in your workshop. Instead of just tossing your old push pads out, George recommends cutting off the rubber padding from the bottom of the pad, and screwing the plastic handle to a piece of scrap wood, which you can turn into…
Watch Now >> -
5:41Cutting Plugs and Using Plug Cutters
Make nearly invisible covers for screw heads with plugs cut from the same wood as your woodworking project. George Vondriska guides you through the procedure for cutting plugs using a drill press, plug cutter bit, bandsaw and George’s secret weapon: masking tape.
Watch Now >>
