You may just have found a new home for your old, worn out socks. Dave Munkittrick gives a quick and handy woodworking tip to prevent clamp scars that can damage your wood. Socks can help avoid the crippling effects that hand clamps are liable to have on your woodworking projects.
-
5:02
Drill and Tap Cast Iron
Woodworkers drill holes in wood all the time but hesitate when it comes to cast iron. Threaded holes in cast iron machine tables are just the solution you need for holding jigs and fixtures. George Vondriska shows how to cut a threaded through or blind hole in cast iron with a center punch, drill, tap…
Watch Now >> -
1:08
Checking Joint Quality
Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process…
Watch Now >> -
3:23
Climb Cutting on a Dovetail Jig
Router bit tearout is a nasty problem when you’re cutting dovetails. So master woodworker George Vondriska shows you how to avoid this devastating problem when completing your woodworking projects by using a technique on a dovetail jig called climb cutting.
Watch Now >> -
4:05
Biscuit Joiner on a Router
Can you cut biscuit joints on the router table you use for your woodworking projects? Sure, but you’ll need to know the steps to get the fit right. Our master woodworker George Vondriska explains the setup of the router as a biscuit joiner and shows you how to make the cuts.
Watch Now >>