Don’t indulge in risky behavior in the shop! Lots of shop accidents happen from trying to handle small woodworking pieces while using power tools. George Vondriska teaches you how to create a small parts holder that’ll let you keep your digits intact as you saw, strip and sand.
-
2:40
Check for Slipping Router Bit Collet
Router bit collets do wear out, but it can be difficult to tell when. In this woodworking instructional video, master woodworker George Vondriska teaches you how to confirm that your jig’s router bit collet is still properly holding router bits without slipping.
Watch Now >> -
1:08
Checking Joint Quality
Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process…
Watch Now >> -
3:36
Clamping Biscuits
It’s time to drop your standard woodworking clamps and check out these clamping biscuits. Master woodworker George Vondriska teaches you how they work and how they can be an easy solution in your woodworking shop for some of those more difficult-to-clamp joints.
Watch Now >> -
1:03
8mm Shanked Router Bits
Did you know that your woodworking router can actually hold and use 8mm shanked router bits? Not 1/4″, not 1/2″, but 8 mm. Master woodworker George Vondriska discusses the calculated method to the madness, and introduces a must-have tool that will allow 8 mm shanked router bits to work in your router. Learn all about…
Watch Now >>