Fly Cutting a CNC Spoilboard

Duration: 5:48

The spoil board on a CNC router is considered a consumable commodity. Whether you’re screwing material down to the spoilboard, or doing through cuts that slightly cut into it, eventually you’re going to have to fly cut or level your spoil board. This video walks you through the process, helping your understand how to set this up on machine.

Other considerations

One reason for fly cutting your spoilboard is because fasteners and through cuts have made it irregular. But here’s something to consider; before using your CNC the first time you should fly cut the spoilboard. What? Why level the board when it’s a perfectly smooth piece of mdf? The reason for leveling the board on a brand new machine is to make certain it’s dead flat, and that the top of the board is perfectly parallel to the travel of the spindle or router. This is a very important step, and can have a huge affect on the accuracy you get from your CNC router.

Router bit selection

While nearly any router bit could be used for leveling a spoilboard, there are distinct characteristics to look for when it comes to choosing the best one. In this video we show you three different router bits, and talk about which one is best for this cut.

More on CNC routers

WoodWorkers Guild of America has been very active in educating woodworkers about CNC routers. Check out our extensive videos about benchtop CNC machines.

Reply to bill
  • (will not be published)

One Response to “Fly Cutting a CNC Spoilboard”
  1. bill
    bill

    I ran a 5×12 CNC for 3 years with a vacuum hold down. I used a 4″ surfacing bit probably every 3 months. It took about 20 minutes but it produced a clean, flat surface. I’m retired now(12 years) thanks for the memories.

    Reply