Watch Dave Munkittrick demonstrate how to apply finish to a turned project right on the lathe. See what he adds to the shellac for a foolproof protective finish for nearly any woodturning project.
You Might Also Enjoy...
-
5:41Make nearly invisible covers for screw heads with plugs cut from the same wood as your woodworking project. George Vondriska guides you through the procedure for cutting plugs using a drill press, plug cutter bit, bandsaw and George’s secret weapon: masking tape.
Watch Now >> -
1:03Did you know that your woodworking router can actually hold and use 8mm shanked router bits? Not 1/4″, not 1/2″, but 8 mm. Master woodworker George Vondriska discusses the calculated method to the madness, and introduces a must-have tool that will allow 8 mm shanked router bits to work in your router. Learn all about…
Watch Now >> -
1:42It is possible to mount a router bit incorrectly in your router collet, and that can spell disaster for your woodworking project. George Vondriska shows you how to properly insert and clamp router bits into your router.
Watch Now >> -
2:28When working on your woodworking project, have you ever wondered why most dovetail jigs are a two-bit operation? Woodworking expert George Vondriska explains how through-pins and tails are cut on a jig, and when to use each of the two cutters required for the process. He also discusses why it’s so important to match the…
Watch Now >>
