George Vondriska puts a piece of wet walnut onto the lathe to demonstrate the benefits of using a bowl gouge to hollow out the interior of a bowl instead of a chisel. Using a GoPro, we give you a close-up look at George’s technique so that you can fully understand how to utilize a bowl gouge for your woodworking needs.
Tags: Cutting a Dado, Premium Videos, Using Hand Tools to Cut a Dado, woodworking joinery
You Might Also Enjoy...
-
1:07Having a hard time getting a good grip on your screwdrivers? Use this quick tip from Dave Munkittrick to make your screwdriver handle larger and easier to grip.
Watch Now >> -
1:08Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process
Watch Now >> -
3:23Router bit tearout is a nasty problem when you’re cutting dovetails. So master woodworker George Vondriska shows you how to avoid this devastating problem when completing your woodworking projects by using a technique on a dovetail jig called climb cutting.
Watch Now >> -
2:32George Vondriska teaches you a great way to refurbish the push pads you use in your workshop. Instead of just tossing your old push pads out, George recommends cutting off the rubber padding from the bottom of the pad, and screwing the plastic handle to a piece of scrap wood, which you can turn into
Watch Now >>
