George Vondriska discusses some of the advantages and disadvantages of the common types of sheet stock you might use in your shop. He’ll teach you what to look for so that you know which material is best for your project, whether its plywood, MDF or melamine. You’ll learn how each type of stock is made, which is the least expensive if you’re working on a budget and which is the heaviest if you’re looking to build something sturdy.
-
1:26
Cutting Laminate on a Table Saw
Master woodworker George Vondriska demonstrates the best way to safely cut perfectly straight plastic laminate with your table saw. You’ll learn that all you need are a couple of scraps to make a handy foolproof woodworking jig.
Watch Now >> -
2:28
2 Bit Dovetail
When working on your woodworking project, have you ever wondered why most dovetail jigs are a two-bit operation? Woodworking expert George Vondriska explains how through-pins and tails are cut on a jig, and when to use each of the two cutters required for the process. He also discusses why it’s so important to match the…
Watch Now >> -
1:08
Checking Joint Quality
Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process…
Watch Now >> -
4:05
Biscuit Joiner on a Router
Can you cut biscuit joints on the router table you use for your woodworking projects? Sure, but you’ll need to know the steps to get the fit right. Our master woodworker George Vondriska explains the setup of the router as a biscuit joiner and shows you how to make the cuts.
Watch Now >>