Mitering the corners on banding that’s being applied to all four edges of a table top can be extremely frustrating. The length of each piece has to be perfect, and each angle needs to be just right. This process calls for a methodical approach, and Charlie Kocourek has that technique nailed down. Follow his recipe, and the banding on each of your projects will be dead on. For a more detailed look at this process, check out Charlie’s related article on the topic.
Can you cut biscuit joints on the router table you use for your woodworking projects? Sure, but you’ll need to know the steps to get the fit right. Our master woodworker George Vondriska explains the setup of the router as a biscuit joiner and shows you how to make the cuts.Watch Now >>
Dovetails are widely viewed in the woodworking world as a mark of premium craftsmanship. Cutting them with variable spacing creates a strong visual appeal, and the appearance of a hand-cut approach. Master woodworker George Vondriska demonstrates how to use a router, dovetail jig and guide block to make concentric variable spaced dovetail joints without the…Watch Now >>
George Vondriska teaches you a great way to refurbish the push pads you use in your workshop. Instead of just tossing your old push pads out, George recommends cutting off the rubber padding from the bottom of the pad, and screwing the plastic handle to a piece of scrap wood, which you can turn into…Watch Now >>
Router bit tearout is a nasty problem when you’re cutting dovetails. So master woodworker George Vondriska shows you how to avoid this devastating problem when completing your woodworking projects by using a technique on a dovetail jig called climb cutting.Watch Now >>