• 3:31

    Choosing a Router Base: Flat vs Round Side

    There are lots of aspects of woodworking that are intuitive. Some, not so much. This is an example of not so much. Routers and Fences One way to guide a router through a cut is to attach a fence to the router, allowing the fence to ride along the edge of your work. An alternative…

    Watch Now >>
  • 3:31

    How to Use a Flush Trim Router Bit with V-Groove

    Most of the time when you’re attaching a face frame to a cabinet carcase you want to finish it so that it is perfectly flush with a seamless appearance between the face frame and the carcase. Every once in a while, however, you may want to create a point of interest in that area. Perhaps…

    Watch Now >>
  • 6:04

    How to Cross Cut with a Router

    So you’re working on a project where you need to cut a big wide slab, perhaps a table or a bench, and you say to yourself “how can I cut this cleanly in such a way that I don’t have to spend the rest of my life sanding the end grain smooth?”. You are correct…

    Watch Now >>
  • 16:55

    Router Technique to Bridge a Crack

    If you are working on a project and the stock has a crack in it, don’t sweat it. You can reinforce the wood, and at the same time add a beautiful detail by installing a beautiful butterfly joint and “celebrating” the imperfection rather than removing it or attempting to hide it. Once you learn how…

    Watch Now >>