Frequently, when your turning spindles on the lathe you need to define specific diameters. This is when using calipers on the lathe comes into play. George Vondriska teaches you the step-by-step process for combining the capabilities of a parting tool and calipers to define specific diameters when using the lathe.
You Might Also Enjoy
-
2:49Acrylic and Polycarbonate Glass
Have you ever wondered what the differences are between acrylic and polycarbonate glass? George Vondriska explains what sets them apart and discusses some of the various woodworking projects that require each type. Watch and learn which type factors into your next woodworking plans.
Watch Now >> -
3:36Clamping Biscuits
It’s time to drop your standard woodworking clamps and check out these clamping biscuits. Master woodworker George Vondriska teaches you how they work and how they can be an easy solution in your woodworking shop for some of those more difficult-to-clamp joints.
Watch Now >> -
2:32Re-Purpose Worn Push Pads
George Vondriska teaches you a great way to refurbish the push pads you use in your workshop. Instead of just tossing your old push pads out, George recommends cutting off the rubber padding from the bottom of the pad, and screwing the plastic handle to a piece of scrap wood, which you can turn into…
Watch Now >> -
1:08Checking Joint Quality
Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process…
Watch Now >>
