Please select from the available subscriptions above
Select your membership plan and get our best woodworking videos, projects and plans with 24/7 access to our woodworking experts, automatic renewal and our ‘cancel anytime’ policy.
Woodworkers drill holes in wood all the time but hesitate when it comes to cast iron. Threaded holes in cast iron machine tables are just the solution you need for holding jigs and fixtures. George Vondriska shows how to cut a threaded through or blind hole in cast iron with a center punch, drill, tap and die set, a little oil drill and an all important back and forth motion.
Tags: cast iron, drill and tap, drill cast iron, George Vondriska, Premium Videos, tap cast iron
Can you cut biscuit joints on the router table you use for your woodworking projects? Sure, but you’ll need to know the steps to get the fit right. Our master woodworker George Vondriska explains the setup of the router as a biscuit joiner and shows you how to make the cuts.
Watch Now >>
It is possible to mount a router bit incorrectly in your router collet, and that can spell disaster for your woodworking project. George Vondriska shows you how to properly insert and clamp router bits into your router.
Watch Now >>
Did you know that your woodworking router can actually hold and use 8mm shanked router bits? Not 1/4″, not 1/2″, but 8 mm. Master woodworker George Vondriska discusses the calculated method to the madness, and introduces a must-have tool that will allow 8 mm shanked router bits to work in your router. Learn all about
Watch Now >>
Make nearly invisible covers for screw heads with plugs cut from the same wood as your woodworking project. George Vondriska guides you through the procedure for cutting plugs using a drill press, plug cutter bit, bandsaw and George’s secret weapon: masking tape.
Watch Now >>