George Vondriska teaches you how to use a piece of melamine as a sacrificial fence for cutting a miter on your miter saw. This will help you to figure out where to make your cut on the miter and will guarantee a more accurate cut.
Tags: cutting miters, Premium Videos
You Might Also Enjoy...
-
1:03Did you know that your woodworking router can actually hold and use 8mm shanked router bits? Not 1/4″, not 1/2″, but 8 mm. Master woodworker George Vondriska discusses the calculated method to the madness, and introduces a must-have tool that will allow 8 mm shanked router bits to work in your router. Learn all about
Watch Now >> -
5:41Make nearly invisible covers for screw heads with plugs cut from the same wood as your woodworking project. George Vondriska guides you through the procedure for cutting plugs using a drill press, plug cutter bit, bandsaw and George’s secret weapon: masking tape.
Watch Now >> -
1:08Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process
Watch Now >> -
3:46George Vondriska discusses some of the advantages and disadvantages of the common types of sheet stock you might use in your shop. He’ll teach you what to look for so that you know which material is best for your project, whether its plywood, MDF or melamine. You’ll learn how each type of stock is made,
Watch Now >>
