We had a GREAT LIVE session September 29th! Our goal was to get LOTS of your questions answered, and to show some cool new products we found at a recent woodworking show. Hopefully you found it a fast-paced hour (or so) of woodworking info.
We covered a wide range of topics including hide glue and its applications, board foot calculations, jigs for routing dadoes with a hand-held router, ebonizing wood, and a whole lot more. Check out the archived video here, and watch for the date of our next WWGOA LIVE.

• What kind of finished did Joanie use on her intarsia projects that were shown on the April 2016 live show?
• What is the difference between sanding sealer and regular unwaxed shellac? When would you use one and not the other?
UNIONTOWN, OHIO
Thanks for this informative session
Great Presentation. Can’t wait for the next one.
Fantastic show
Thanks George !!!
Location: City of Hamilton,North Island, New Zealand. Best wishes. David Boyd.
Just want to say THANKS! I enjoy these!
watching from Brisbane Australia
Not nearly as far away as other viewers, but greetings from Lake County, California! Thanks for another great live show.
Viewing live right now in New Zealand. Our time 2.50 pm Wed 30th.
Just listening in at the moment. From Houghton, NY (60 miles south of Buffalo)
I’m wanting to put a good dust collection set up in my shop. any suggestions/tips?
Hello from COlombia
I agree with George on the table saw height. I speak from experience and four surgeries to rebuild my left hand. SAFETY FIRST!
How difficult would it be to turn a pre-fabricated cabinet door into an open glass design door?
Where can I get easy to follow directions for making flat panel cabinets doors?
I have seen much on raised and not so much on flat panel. I want to make sure they are flat and joined properly
Thank you very much
The door will be over 100″ tall 26″ wide
What is the easiest way to keep larger carcases (2 feet by 4 feet) squared while the glue dries.
Is it necessary when making large cabinet door to include extra rails and if so how often??
How hard is it to change the knives on a Delta surface sander? and what is a good glue to use on wood in Dessert areas?
Have you ever tried vacuum infusing for creating colored thicker (3/32″) veneers?
After seeing your segment on CNC. Have you ever checked out the X-Carve CNC machine? It’s availble to wood workers for less than $1500.00 U.S. at https://www.inventables.com/technologies/x-carve.
you made a comment about the speed in which the drill press should run do to the size of the bits when drilling holes, how does wood hardness play into this? Should i drill a larger hole in a harder wood faster or slower than a softer wood?
Hello!
adhesive vs glue
Do you recommend a specific type of wood for turning pens?
interesting topic
My first live look—-I want to see what it encompasses