• 5:06

    If you are making a plaque or a picture frame and want to integrate a slot into the project so that the user can easily hang the piece on a wall without having to use hanging hardware, there is a special router bit called a keyhole bit that can be used for this purpose. The

    Read more »

    Watch Now >>
  • 11:34

    Dado joints are a time-honored approach for case joinery. When choosing to use a router to create this joint, router table setup is critical to creating the perfect fit that you’re after. On a table saw equipped with a dado head you would use shims to dial in the perfect width for your dado, but

    Read more »

    Watch Now >>
  • The Importance of Making Downhill Cuts with a Router
    7:43

    Demonstrating on a tapered display case, George Vondriska teaches you why you should always make downhill cuts when doing a taper for a woodworking project to optimize the surface finish of the edge. He discusses which router bits you should use, and then shows you the expert woodworking techniques you’ll need to utilize to make

    Read more »

    Watch Now >>
  • Chip-Free Flush Trimming
    3:13

    Demonstrating on cathedral raised-panel doors, George Vondriska teaches you how to get a flush trim with a curved piece of wood to a pattern template using an Ultimate Trim Bit on the router table. His expert woodworking technique and this specialized router bit will guarantee you a smooth, chip-free flush trimming cut on both the

    Read more »

    Watch Now >>
  • Raised Panel Router Bits: Vertical Raised Panel Bit
    6:08

    George Vondriska shows you how to make raised panel doors using a vertical raised panel bit on your router table. He will go through the process of creating a raised panel and the positives and negatives of using a vertical panel raiser bit vs. a horizontal panel raiser.

    Watch Now >>
  • How to Install a Router Bit in a Router
    1:42

    George Vondriska demonstrates the easy woodworking technique for how to install a router bit in your router correctly. He recommends that you take the base off of the motor, then talks about the possible consequences of mounting the bit too far or not far enough.

    Watch Now >>
  • Vertical Panel Raiser
    5:31

    Thinking of buying a vertical panel raiser for your router table? George Vondriska demonstrates how to safely use the bit and discusses some of the pros and cons of the vertical panel router bits and the classic horizontal panel bits.

    Watch Now >>
  • Using an Edge Beading Router Bit
    4:53

    Using an edge beading router bit is a fast and easy way to add creative decoration to your project. George Vondriska shows you the setup, process and results of using this unique router bit.

    Watch Now >>
  • Spiral Router Bits
    3:53

    Spiral router bits have numerous uses in your woodworking projects. Master woodworker George Vondriska shows the two types of spiral router bits and the advantages of each over traditional straight bits. A WoodWorkers Guild of America (WWGOA) original video.

    Watch Now >>