• Wood Lathe: Protect Your Lathe Tool Rest
    2:13

    Wood Lathe: Protect Your Lathe Tool Rest

    If your lathe chisels, especially skews, have sharp corners on them, they’re probably digging into the lathe tool rest every time you use them. That makes for a lot of filing to keep the tool rest smooth. Here’s an easy way to make sure your chisels never get the chance to dig into the lathe…

    Watch Now >>
  • Straightening a Lathe Tool Rest
    3:30

    Straightening a Lathe Tool Rest

    Wood lathes don’t require too much maintenance, but to keep your cuts going smoothly you should give the tool rest some TLC every once in a while. It’s easy to do, and will make your lathe work go much better. Related Video: Wood Lathe: Protect Your Lathe Tool Rest

    Watch Now >>
  • Cleaning the Worm Screw on Your Table Saw
    6:24

    Cleaning the Worm Screw on Your Table Saw

    Does your table saw (and your arm) complain every time you raise and lower the blade or change the blade angle? A little bit of cleaning will go a long way toward making your saw easier to operate. It’s all about cleaning and properly lubricating the worm screw and the trunnion.

    Watch Now >>
  • How to Clean Rust Off a Table Saw
    3:25

    How to Clean Rust Off a Table Saw

    Learn some helpful tips on how to clean rust off a table saw. If your table saw has a cast iron top even the slightest amount of moisture contacting it can leave water marks and eventually rust spots. George Vondriska shows you how to remove and avoid rust spots by using rust remover, fine grit…

    Watch Now >>
  • Woodworking Tools Setup and Maintenance
    1:39:02

    Woodworking Tools Setup and Maintenance

    Woodworking requires you to be exact, and the first step to making perfect measurements and cuts is to have properly maintained equipment. Naturally, woodworking tools loosen, wear down and lose their effectiveness, so it is extremely important to regularly check and take care of your woodworking machinery so it stays in top form. In this…

    Watch Now >>
  • Lathe Maintenance
    3:06

    Lathe Maintenance

    Lathes take a lot of abuse from the moisture from wood turnings, and it’s a good idea to care for your lathe as part of a routine maintenance effort. Woodworking expert George Vondriska shows how he keeps his lathe running at peak performance at all times. A WoodWorkers Guild of America (WWGOA) original video.

    Watch Now >>
  • How to Calibrate a Table Saw Fence
    2:45

    How to Calibrate a Table Saw Fence

    Bruce Kieffer is a professional furniture maker who always wants his tools to be as accurate as possible. In this clip, he demonstrates his woodworking technique for calibrating his table saw fence so you can make dead-on cuts every time. A WoodWorker Guild of America (WWGOA) original video.

    Watch Now >>
  • Protect Your Air Guns
    1:05

    Protect Your Air Guns

    Although it’s not quite like winning the Masters Tournament, this is one tip you’ll never forget. An ounce of prevention can keep your air guns running at peak performance.

    Watch Now >>