• Proper Handling of a Hand Plane
    1:35

    Get off on the right foot with your hand planing skills. Adam Peterson shows you how to hold and position the woodworking hand plane along with the the proper motion and pressure shifts to successfully joint an edge.

    Watch Now >>
  • Making the Tail of Sliding Dovetail Joint
    4:54

    Sliding dovetail joints are super strong. Master woodworker George Vondriska shows you how to set up and rout dovetails on a router table.

    Watch Now >>
  • Concentric Variable Spaced Dovetails
    3:40

    Dovetails are widely viewed in the woodworking world as a mark of premium craftsmanship. Cutting them with variable spacing creates a strong visual appeal, and the appearance of a hand-cut approach. Master woodworker George Vondriska demonstrates how to use a router, dovetail jig and guide block to make concentric variable spaced dovetail joints without the

    Read more »

    Watch Now >>
  • Climb Cutting on a Dovetail Jig
    3:23

    Router bit tearout is a nasty problem when you’re cutting dovetails. So master woodworker George Vondriska shows you how to avoid this devastating problem when completing your woodworking projects by using a technique on a dovetail jig called climb cutting.

    Watch Now >>
  • Clamping Biscuits
    3:36

    It’s time to drop your standard woodworking clamps and check out these clamping biscuits. Master woodworker George Vondriska teaches you how they work and how they can be an easy solution in your woodworking shop for some of those more difficult-to-clamp joints.

    Watch Now >>
  • Biscuit Joiner on a Router
    4:05

    Can you cut biscuit joints on the router table you use for your woodworking projects? Sure, but you’ll need to know the steps to get the fit right. Our master woodworker George Vondriska explains the setup of the router as a biscuit joiner and shows you how to make the cuts.

    Watch Now >>
  • 2 Bit Dovetail
    2:28

    When working on your woodworking project, have you ever wondered why most dovetail jigs are a two-bit operation? Woodworking expert George Vondriska explains how through-pins and tails are cut on a jig, and when to use each of the two cutters required for the process. He also discusses why it’s so important to match the

    Read more »

    Watch Now >>