• How to Make Base Molding
    3:45

    George Vondriska demonstrates how to make shop-made base molding. A WoodWorkers Guild of America (WWGOA) original video. Cooper Collection Clocks 49022 Madison Clock Plans provided by Klockit. For more information, visit www.klockit.com. More Videos from Klockit: Klockit Leg to Rail Joinery Methods Klockit Shop-Made Curve Molding

    Watch Now >>
  • Shop-Made Curve Molding
    7:01

    George Vondriska demonstrates how to make shop-made curve molding for your woodworking projects. A WoodWorkers Guild of America (WWGOA) original video. 49167 Mora Clock Plans provided by Klockit. For more information, visit www.klockit.com. More Videos from Klockit: Klockit Leg to Rail Joinery Methods How to Make Base Molding

    Watch Now >>
  • Zero-Clearance Router Table Fence
    4:18

    From drawer lock joints to rail and stile doors, it stinks when your projects end up with ugly chips and tear out caused by the router table. A zero-clearance fence is a simple solution to this common problem. Don’t let the chips fall where they may. Eliminate them! A WoodWorkers Guild of America (WWGOA) original

    Read more ยป

    Watch Now >>
  • Trimming Edge Banding on the Router Table
    7:02

    George Vondriska shows you how to trim edge banding for your woodworking projects using a router table. A WoodWorkers Guild of America (WWGOA) original video.

    Watch Now >>
  • Spiral Router Bits
    3:53

    Spiral router bits have numerous uses in your woodworking projects. Master woodworker George Vondriska shows the two types of spiral router bits and the advantages of each over traditional straight bits. A WoodWorkers Guild of America (WWGOA) original video.

    Watch Now >>
  • Simplified Router Fence Setup
    8:43

    George Vondriska provides an easy way to set up a router fence. A WoodWorkers Guild of America (WWGOA) original video. Setup Tool provided by Prazi. For more information, visit www.praziusa.com. More Videos provided by Prazi: Dovetail Jig Buying Advice

    Watch Now >>
  • Junior Door Sets
    3:11

    When you have a smaller DIY woodworking project with raised-panel doors, standard panel bits would create panels that look out of scale with the door design. Master woodworker George Vondriska teaches you about the value of junior door sets in this type of project. A WoodWorkers Guild of America (WWGOA) original video.

    Watch Now >>
  • Biscuit Joiner on a Router
    4:05

    Can you cut biscuit joints on the router table you use for your woodworking projects? Sure, but you’ll need to know the steps to get the fit right. Our master woodworker George Vondriska explains the setup of the router as a biscuit joiner and shows you how to make the cuts.

    Watch Now >>