Furniture Making
-
4:54
Making the Tail of Sliding Dovetail Joint
Sliding dovetail joints are super strong. Master woodworker George Vondriska shows you how to set up and rout dovetails on a router table.
Watch Now >> -
2:36
Leveling Edge Banding with a Belt Sander
Plywood edgebanding is best applied slightly wide and then sanded flush using a belt sander. Woodworking expert Bruce Kieffer shows you how to do this type of belt sanding without sanding through the plywood veneer or gouging the panel.
Watch Now >> -
5:30
Laying Out Circular Rails
Building the circular rails for a round table can be intimidating. Master woodworker George Vondriska breaks down the steps using a straightforward approach, and you might be surprised to see how stress-free you can make this rather difficult woodworking process.
Watch Now >> -
1:08
Checking Joint Quality
Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process…
Watch Now >> -
2:56
Bending Wood with a Hot Pipe
Bending wood is one of those techniques that can have a dramatic effect on a woodworking project, but many woodworkers shy away from it because it seems intimidating. Watch this demonstration by our expert woodworker George Vondriska to learn a simple, worry-free approach to bending wood quickly using a heated iron pipe.
Watch Now >>