• Designing a Project Piece Using CAD
    5:57

    George Vondriska and Bruce Kieffer demonstrate the quick process for designing a woodworking project piece using a CAD program. A Woodworkers Guild of America (WWGOA) original video.

    Watch Now >>
  • Cabinet Door Assembly
    7:53

    When creating a cabinet door, it is critical to keep the wood flat and square. George Vondriska provides practical tips on how to assemble door panels using a parallel jaw clamp. A WoodWorkers Guild of America (WWGOA) original video. Steel Bar Clamps provided by Jorgensen. For more information, visit www.ponytools.com

    Watch Now >>
  • Making the Tail of Sliding Dovetail Joint
    4:54

    Sliding dovetail joints are super strong. Master woodworker George Vondriska shows you how to set up and rout dovetails on a router table.

    Watch Now >>
  • Leveling Edge Banding With A Belt Sander
    2:36

    Plywood edgebanding is best applied slightly wide and then sanded flush using a belt sander. Woodworking expert Bruce Kieffer shows you how to do this type of belt sanding without sanding through the plywood veneer or gouging the panel.

    Watch Now >>
  • Concentric Variable Spaced Dovetails
    3:40

    Dovetails are widely viewed in the woodworking world as a mark of premium craftsmanship. Cutting them with variable spacing creates a strong visual appeal, and the appearance of a hand-cut approach. Master woodworker George Vondriska demonstrates how to use a router, dovetail jig and guide block to make concentric variable spaced dovetail joints without the

    Read more »

    Watch Now >>
  • Climb Cutting on a Dovetail Jig
    3:23

    Router bit tearout is a nasty problem when you’re cutting dovetails. So master woodworker George Vondriska shows you how to avoid this devastating problem when completing your woodworking projects by using a technique on a dovetail jig called climb cutting.

    Watch Now >>
  • Checking Joint Quality
    1:08

    Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process

    Read more »

    Watch Now >>