When you change the blade on your bandsaw, you need to remove that little pin in the slot of the band saw table. Don’t throw it away! George Vondriska teaches you why.
George Vondriska teaches you a great way to refurbish the push pads you use in your workshop. Instead of just tossing your old push pads out, George recommends cutting off the rubber padding from the bottom of the pad, and screwing the plastic handle to a piece of scrap wood, which you can turn into…Watch Now >>
Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process…Watch Now >>
Is the bridge of your guitar separating from the guitar top? You can save big bucks by making the repair yourself. You probably already have all the woodworking tools you need in your shop to fix the broken guitar, and if you follow master woodworker George Vondriska’s step-by-step directions in this video, you’ll gain all…Watch Now >>
When working on your woodworking project, have you ever wondered why most dovetail jigs are a two-bit operation? Woodworking expert George Vondriska explains how through-pins and tails are cut on a jig, and when to use each of the two cutters required for the process. He also discusses why it’s so important to match the…Watch Now >>