Make nearly invisible covers for screw heads with plugs cut from the same wood as your woodworking project. George Vondriska guides you through the procedure for cutting plugs using a drill press, plug cutter bit, bandsaw and George’s secret weapon: masking tape.
You Might Also Enjoy...
-
3:59Adding Tannins to Wood
George Vondriska demonstrates a unique way to color wood using a simple iron acetate solution that creates a chemical reaction with the natural tannins in wood. If you are using a wood species with a low level of tannin, George shows you the process for adding tannins so that the iron acetate will have a…
Watch Now >> -
5:02Drill and Tap Cast Iron
Woodworkers drill holes in wood all the time but hesitate when it comes to cast iron. Threaded holes in cast iron machine tables are just the solution you need for holding jigs and fixtures. George Vondriska shows how to cut a threaded through or blind hole in cast iron with a center punch, drill, tap…
Watch Now >> -
1:08Checking Joint Quality
Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process…
Watch Now >> -
1:29Preventing Clamp Scars
You may just have found a new home for your old, worn out socks. Dave Munkittrick gives a quick and handy woodworking tip to prevent clamp scars that can damage your wood. Socks can help avoid the crippling effects that hand clamps are liable to have on your woodworking projects.
Watch Now >>
