The problem with providing outfeed support for a bandsaw is that the table is so darn high. Most standard roller stands and supports won’t extend enough to get to the right height to match up with the bandsaw table. You may not know it, but you’ve probably already got a solution for this problem in your shop. Once you see it you’ll be saying “Why didn’t I think of that?” And you’ll be sure to use it for the next large woodworking project you have to cut on the bandsaw.
-
1:34
Do I Really Need an Impact Driver?
Seeing is believing! Watch this demonstration and don’t be surprised if your next tool purchase is an impact driver. For more information about impact drivers check out the related impact driver product review.
Watch Now >> -
2:28
2 Bit Dovetail
When working on your woodworking project, have you ever wondered why most dovetail jigs are a two-bit operation? Woodworking expert George Vondriska explains how through-pins and tails are cut on a jig, and when to use each of the two cutters required for the process. He also discusses why it’s so important to match the…
Watch Now >> -
2:40
Check for Slipping Router Bit Collet
Router bit collets do wear out, but it can be difficult to tell when. In this woodworking instructional video, master woodworker George Vondriska teaches you how to confirm that your jig’s router bit collet is still properly holding router bits without slipping.
Watch Now >> -
1:03
8mm Shanked Router Bits
Did you know that your woodworking router can actually hold and use 8mm shanked router bits? Not 1/4″, not 1/2″, but 8 mm. Master woodworker George Vondriska discusses the calculated method to the madness, and introduces a must-have tool that will allow 8 mm shanked router bits to work in your router. Learn all about…
Watch Now >>