Amaze all your woodworking buddies by showing off a perfectly polished soapstone project! George Vondriska teaches you how to properly sand a piece of soapstone and polishing soapstone with a rubbing compound from an auto parts store to remove all the sanding scratches and make the unique patterns of your soapstone pop.
You Might Also Enjoy...
-
1:038mm Shanked Router Bits
Did you know that your woodworking router can actually hold and use 8mm shanked router bits? Not 1/4″, not 1/2″, but 8 mm. Master woodworker George Vondriska discusses the calculated method to the madness, and introduces a must-have tool that will allow 8 mm shanked router bits to work in your router. Learn all about…
Watch Now >> -
1:08Checking Joint Quality
Good joinery starts with surfaces that mate perfectly without use of clamp pressure. If excessive clamping pressure is used to pull the joint together, it will create stress on your woodworking project that can cause distortion or even splitting to occur. Master woodworker George Vondriska explains how to incorporate a “dry run” into your process…
Watch Now >> -
1:26Cutting Laminate on a Table Saw
Master woodworker George Vondriska demonstrates the best way to safely cut perfectly straight plastic laminate with your table saw. You’ll learn that all you need are a couple of scraps to make a handy foolproof woodworking jig.
Watch Now >> -
3:23Climb Cutting on a Dovetail Jig
Router bit tearout is a nasty problem when you’re cutting dovetails. So master woodworker George Vondriska shows you how to avoid this devastating problem when completing your woodworking projects by using a technique on a dovetail jig called climb cutting.
Watch Now >>
