Does your table saw (and your arm) complain every time you raise and lower the blade or change the blade angle? A little bit of cleaning will go a long way toward making your saw easier to operate. It’s all about cleaning and properly lubricating the worm screw and the trunnion.
Router bit collets do wear out, but it can be difficult to tell when. In this woodworking instructional video, master woodworker George Vondriska teaches you how to confirm that your jig’s router bit collet is still properly holding router bits without slipping.Watch Now >>
George Vondriska teaches you a great way to refurbish the push pads you use in your workshop. Instead of just tossing your old push pads out, George recommends cutting off the rubber padding from the bottom of the pad, and screwing the plastic handle to a piece of scrap wood, which you can turn intoWatch Now >>
Router bit tearout is a nasty problem when you’re cutting dovetails. So master woodworker George Vondriska shows you how to avoid this devastating problem when completing your woodworking projects by using a technique on a dovetail jig called climb cutting.Watch Now >>