Power Tool Woodworking

Sort by:

  • Router Technique to Bridge a Crack

    If you are working on a project and the stock has a crack in it, don’t sweat it. You can reinforce the wood, and at the same time add a beautiful detail by installing a beautiful butterfly joint and “celebrating” the imperfection rather than removing it or attempting to hide it. Once you learn how… Read more »

  • How to Cross Cut Accurately on a Table Saw

    The table saw is perhaps best known for its prowess in lumber ripping operations, but with a little bit of time and setup, you can also learn how to cross cut like a boss on your table saw. It’s simple to turn your table saw into a precision cross cutting machine, and once you know… Read more »

  • Router Dust Collection with the Oneida Router Hood

    Router Dust Collection with the Oneida Router Hood

    Routers make a mess, there are no two ways around around it. And it’s always been hard to achieve good router dust collection, at least until now. The new Universal Dust-Free Router Hood from Oneida Air Systems provides a great solution to the problem of dust coming pouring off of your hand-held router. Attaching the… Read more »

  • How to Set a Miter Gauge for 45 Degrees

    Setting the miter gauge on your table saw to a perfect 45-degrees can be very challenging. And, if you’re planning on making picture frames, being just a tiny bit off will be a deal breaker. But here’s great news. You’ve probably already got a tool in your shop that will give you the precision you… Read more »

  • Framing Square Cutting Guide

    Framing Square Cutting Guide

    Making a square end cut with a circular saw can be an intimidating proposition. You can measure, double check, draw a line, measure again, and then when you cut you might still find that it is out of square. Ugh! Don’t give up and use out-of-square cuts for your project; that won’t do. Also, don’t… Read more »

  • Overcome Chatter on the Lathe

    Overcome Chatter on the Lathe

    You can turn just about anything that is round on a lathe, within the length and diameter constraints of your machine. But when you turn a spindle to a long, thin shape, you will invariably encounter the work piece beginning to vibrate under pressure from your lathe chisel. The next thing that you’ll notice is… Read more »

  • Jointing Boards Wider than Your Jointer

    Jointing Boards Wider Than Your Jointer

    Most woodworkers try to buy a jointer that has enough capacity to handle any board that we would want to face joint or edge joint. But let’s face it; jointing boards wider than your jointer is a requirement that many woodworkers face from time to time. First of all, you should look at this challenge… Read more »

  • How to Taper Cut on a Jointer

    How to Taper Cut on a Jointer

    Do you know how to taper cut on your jointer? When most people think about a motorized jointer they think about edge jointing and face jointing. And for good reason; those two activities comprise the large majority of what woodworkers use their jointers for. If you ask most woodworkers how to taper cut, they will… Read more »

  • Edge to Edge Glue Up on a Jointer: Wood Gluing Tips

    Edge to Edge Gluing: Perfect Jointer Cuts

    Edge gluing comes into play in a variety of woodworking projects, and is an aspect of any project that can reveal the skill level of the craftsman who builds the project. A dead flat panel is impressive and indicates a high quality project. But let’s face it; if the panel has gaps or noticeable peaks… Read more »

  • Spacers Create Perfect Dado Fit

    Sure, it’s great to cut dadoes using a dado head on a table saw, or a router bit on a router table or with a hand-held router. But there are instances where that may not work for you. Maybe you don’t own a dado head, or the right size router bit. Or maybe you’re only… Read more »