Many times I need to rip some pieces, and may need to rip the same size pieces later, after moving the fence. I came up with the setup in the picture. Just slide the setup jig against the fence, and tighten the knob enough to lock the sliding arm to the piece in the miter
Tablesaws
Super Accurate Table Saw Fence Setting
Sometimes cumulative error can be your worst enemy, and other times it can be your best friend. You’ll love it when you use it to set your table saw fence! When you’re done you’ll have set your fence five times more accurately than any other way I know. Here’s what you do: Set your saw
Ask WWGOA: Track Saw vs. Table Saw
Question: Has WWGOA done a piece on the Dewalt or other Track Saw? I’m evaluating table saws and a new tool has come to my attention, the Dewalt Track Saw. I’m looking for bang-for-the buck, with the desire to stay under $1,000. I have >1,000 sf to work with, but I will do most of
Table Saw Fence Adjustment or Upgrade
“I have a relic of a table saw. It is a Delta 8″ arbor saw. My frustration is this. When I use it, the back half of the table saw fence does not stay in place. It will move anywhere from 1/4″ to 3/8”. I take all of the necessary precautions in measuring from the
How to Remove Rust from Table Saws
“I am looking at a used 10″ table saw to replace my very old one. The top has a light coating of rust from just sitting in the garage. How is the best way to remove it, if possible?” Submitted by: brandenbergs WWGOA Editor Response: I’ve had great luck getting surface rust off tools using