What to Know About Powermatic’s New Lathe

picture of the woodworking tool that is discussed throughout the article

Powermatic has rolled out their PM2014 Wood Lathe ($1999.99). It’ll handle 20” between centers and has a 14” swing over the bed. Add a bed extension ($249.99), and you can increase spindle length to 43”, plus do larger outboard turnings. The PM2014 weighs 185 pounds by itself, 238 pounds when mounted to the stand.

Power

You can plug the PM2014 into a 115V outlet, and it converts that to 230V three phase power for the machine. It’s equipped with a 1 hp motor and has three speed ranges; 15-900 RPM, 30-1800 RPM and 60-3600 RPM.

The Stand

A stand is available for this machine that is height adjustable, allowing you to set the floor to centerline height from 34” to 46”. The price for the machine and stand is $2399.99.

www.powermatic.com

When you’re ready to put the lathe to work you’ll get lots of inspiration from our extensive collection of woodturning videos.

Reply to Jay
  • (will not be published)

3 Responses to “What to Know About Powermatic’s New Lathe”
    • Customer Service
      Customer Service

      Hello Wayne,
      Thank you for your feedback. I have forwarded your comment to the proper department. We value your opinion, and it will help with the development of our online streaming community. We will continue to listen and work hard for your complete satisfaction.
      Please let us know if you have any further questions
      Sincerely,
      Danesha
      Wood Workers Guild of America Video Membership

      Reply
  1. Jay
    Jay

    This is way over-priced for a midi-lathe. The Jet 1440 is $1700+ and is frequently on sale for 10-15% off. It’s length is adequate for anything you are likely to turn except for maybe 7′ tall, canopy, bedposts (which are safer to turn in 2 sections, anyway). The adjustable height of this Powermatic is nice, but the shear weight of the lathe will make raising it or lowering it without a shop crane very difficult. Being “vertically challenged” myself, my Jet lathe is too high for me, so I made a long step stool/bench to stand on when using it – problem solved! It’s functionally better to use a lathe on a workbench where you then will have access to your turning knives, ruler, caliper, sandpaper and light source. There is absolutely no need for a DRO. Whether the lathe speed is 1200 or 1250 RPM makes no significant difference. If the speed is too fast, you just slow it down, etc.

    Reply