Handmade Graduated Butterflies Are Stunning
The butterflies or ‘dutchmen’ embedded in this desktop are custom sized and cut on a bandsaw. Butterflies stabilize the crack and also provide a focal point on top of the desk to highlight your woodworking skills. When making butterfly joints, I tend to avoid templates available at woodworking stores. In my opinion, these templates result in blocky butterflies that have too steep an angle and aren’t as aesthetically pleasing. Besides, if you want something to look uniquely handmade, make it unique and by hand!!! I’ll show you how on a beautiful slab of elm I plan to use for a small side table.
Make Multiple Mock-Up Butterflies to Check for Scale and Proportion
I set my adjustable angle finder at 8 degrees and mock-up butterflies out of 1/8” plywood. I make multiple iterations in different lengths and widths, allowing me to slide the butterflies around and see if the scale and proportion are right, as well as check for positioning. I don’t have a formula for the dimensions of each butterfly, but too big, and the butterfly feels overkill, too small and it seems like an afterthought. I make mine 1/3 to 1/2 the thickness of the slab and utilize one near the edge and another every 5”-8”. The size of the butterfly has two references: the size of the slab and the size of the crack. They get gradually smaller as the crack gets smaller. Once I settle on the size, I transfer the dimensions to my butterfly blank, which I have made out of contrasting walnut, and cut out the shape on the bandsaw.
Sand the Edges of the Butterflies
No matter how perfect my technique, the bandsaw blade leaves a slightly imperfect edge on the butterfly. To clean up the edge, I make a sanding block by adhering a half-sheet of 150 grit sandpaper to a flat block of hard maple with double stick tape. I align the waist of the butterfly with the crisp edge of the maple block and move the butterfly rather than move the sanding block. Five or six swipes on each facet of the walnut are all it takes to clean up the butterfly. Harder exotic woods may take longer than walnut, but this technique is still effective.
Mark the Placement of the Butterflies
I carefully replace the mock-up butterflies with the real ones and trace them in place. A carpenter’s pencil isn’t suitable for this task, or even a #2, which is soft, and dulls easily. My pencil of choice is mechanical with a .07 mm lead. It’s thick enough to withstand rough wood grain, but fine enough to accurately mark an important tabletop cut. Because the butterflies will not be exactly symmetrical, it is essential to mark the orientation of each butterfly.
Mortise the Tabletop
Chisel to the Line
After the bulk of the waste is cleaned out, I carefully pare to the line with sharp chisels, double-checking often with the butterfly to make sure I’ve not pared too much away. Pen-knives are excellent for cleaning out the acute corners. Once the mortises are cleaned out, I glue the butterfly in place with Titebond III. If the butterfly is an oily exotic species like Cocobolo, I use epoxy.
A Stable and Beautiful Tabletop
Once the glue is dried I saw off the top of the butterfly with a Japanese saw. Traditionalists are welcome to use a hand planes for the final finish, however the 90-degree opposing wood grain presents a potential problem. For me, I normally hand sand with the grain before applying finish. I prefer a random orbit sander, finishing with 320-grit sandpaper, which ensures there are no issues with tear out or cross grain sanding marks. Now, the tabletop is stable and beautiful. A winning combination!